Cleaning and Maintenance
Polished concrete
- Always keep floor vacuumed and dirt free.
- Spills should be cleaned from polish concrete surface immediately.
- Do not use bleach or citrus based cleaners on the floor.
- Furniture should have protective pads placed under them.
- Micro fibre mop is best used to keep floor clean and streak free.
- Areas where heavy soiling exists will require localised cleaning prior to cleaning entire Polished Concrete area.
- In high traffic areas; burnish daily with a high speed burnisher using red nylon pads.
- Where cleaning of the floor with detergent is required:
- Use and PH Neutral Floor care cleaning Solution.
- Either apply the Floor Care solution via use of Auto Scrubber or:
- Apply the Floor Care solution via mop with clean water.
- In either situation, always rinse floor with clean water after use.
Grind and Seal
- Floor coatings take 5-7 days to fully cure.
- Always keep floor vacuumed and dirt free.
- Furniture should have protective pads placed under them.
- Micro fibre mop is best used to keep floor clean and streak free using a low ph cleaner.
- Spills should be cleaned from surface coatings immediately.
We recommend the re-application of surface coatings every 5 years depending if it is a High traffic area.
Epoxy maintenance
- Spills should be cleaned from Epoxy surface immediately.
- Areas where heavy soiling exists will require localised cleaning prior to cleaning entire Epoxy area.
- Where cleaning of the floor with detergent is required:
- Use and PH Neutral Floor care cleaning Solution.
- Either apply the Floor Care solution via use of Auto Scrubber or:
- Apply the Floor Care solution via mop with clean water.
- In either situation, always rinse floor with clean water after use.
For low traffic areas; Use the above steps when necessary
We recommend the re-application of Epoxy approximately every 10 years depending on use.